| BRASS THREAD INSERTS INSTALLATION INSTRUCTIONS
1) Carefully lift and turn speaker onto its top 2) Using a tape measure or square, mark hole locations from each side of the speaker as shown below. This is usually a measurement of 1 1/4" to 1 3/4" from the sides and 1" to 1 1/4" from the front or back of the speaker base. Keep the dimensions you choose equal on all four corners. |
|||||||||||||||||||
 |
|||||||||||||||||||
|
BTI-A
|
|||||||||||||||||||
 |
|||||||||||||||||||
|
BTI-B
|
|||||||||||||||||||
 |
 |
||||||||||||||||||
 |
|||||||||||||||||||
|
BTI-C
|
|||||||||||||||||||
| 3) Next, select the proper drill bit using the following chart. | |||||||||||||||||||
|
|||||||||||||||||||
| Use a drill stop or wrap masking tape around the appropriate size drill bit (as shown below) to use as a depth gauge. Drill holes to appropriate depth with said diameter bit as per chart above. | |||||||||||||||||||
 |
|||||||||||||||||||
| 4) With a large blade screwdriver, screw in the thread insert until it is flush with the bottom of the speaker enclosure. FOR MAXIMUM RESULTS... Thread in a short bolt (matching the thread of insert) into the insert. Then use the correct wrench to drive the insert until flush with the bottom of the cabinet. Remove bolt.
5) Screw the threaded Audio Points™ into the inserts. Turn speaker right side up not allowing any presssure to be placed on the side of the Audio Points™ and maneuver into position. 6) Enjoy! |
|||||||||||||||||||